• page_banner

JS News

Brief Introduction and Precautions for Use of Electric Tools — Electric Hammer

Electric hammer is one of the indispensable electric tools in the decoration and construction industry. Electric hammers rely on rotation and hammering to operate. A single hammering force is very high, and has a hammering frequency of 1000 to 3000 per minute, which can produce significant hammering force. Compared with impact drills, electric hammers require minimal pressure to drill holes in hard materials, such as concrete and bricks.

The correct use method can improve the service life of the electric hammer and prolong the service time of the electric hammer.

1. Before using the electric hammer, carefully observe the identification nameplate of the electric hammer to see whether the voltage conforms to ensure that the electric hammer has no fault.

2. When the electric hammer is working, it is strictly forbidden to rotate the function handle to convert the speed, positive and negative rotation, etc.

3. Protective equipment such as protective cover shall be used when using electric hammer.

4. Electric hammer is a tool for intermittent operation. It cannot be operated continuously for a long time to avoid damaging the tool.

5. When the electric hammer is finishing drilling, the power button should not be released immediately, but should be pulled out of the hole while the drill bit keeps rotating, and then the power button should be released, otherwise the drill bit may be stuck in the hole and cannot be pulled out. In case the drill bit is stuck in the hole, it is strictly prohibited to press the power switch again to start the electric hammer. Otherwise serious injury may be caused, such as the damage of the electric hammer, and even more serious injury to the user. At this time, the drill bit must be separated from the electric hammer first, and then take out the drill bit by other methods.

6. The use of electric hammer should also pay attention to the use environment and temperature. For example, in cold areas, it should idle for two minutes before use. During the drilling process, do not block the heat dissipation vent of electric hammer.

Be careful when using electric hammer to prevent injury. Cause unnecessary damage.


Post time: Jul-22-2022